日韩精品免费观看99_久热这里精品国产_歐美日韓高清不卡一區二區三區_国产一级毛片电影国语版_91香蕉视频免费版_AV天堂岛在线观看_成人在线免费观看亚洲_初见直播app最新_亚州一级毛片在线_动漫 亚洲 自拍

Vacuum pump has selective pumping, so sometimes one kind of pump can't meet the requirement of air pumping. It needs several kinds of pumps to combine and supplement each other to meet the pumping requirements. If the titanium sublimation pump has a high pumping speed for hydrogen, but can not pump helium, and the tripolar sputtering ion pump (or bipolar asymmetric cathode sputtering ion pump) has a certain pumping speed for argon, the combination of the two will make the vacuum device get better vacuum degree.

1、 Causes of high temperature of vacuum pump:

Fan speed is low, air pressure, air volume is small. The motor has high power, high working current and high heat output. The number of fan blades is less and the air volume is small. The bus voltage of the vacuum pump motor is 380V. Due to the cable voltage drop and uneven load distribution, the actual voltage applied by the motor is only 365v. The low voltage results in large operating current. Motor with dust, oil, reduce the heat dissipation capacity.

Solution: motor power, speed and vacuum pump matching, can not be changed. The fan is installed on the main shaft of the motor. The speed of the motor determines the speed of the fan and cannot be replaced. Although increasing the number of fan blades can play a certain role, but the dynamic balance is not easy to find after the number of blades is increased. If the alignment is not good, the motor vibration will increase. The original fan cover was lengthened by 40cm, and an axial flow fan with the same diameter as the fan cover was installed. The motor power of the axial fan was 850W, the speed was 1489r / min, and the voltage was 380V. The original fan remains. The axial fan clothing school has another power supply control, and the axial fan and the main motor are not interlocked. After the vacuum pump is started, the axial flow fan shall be started in time, and the axial flow fan shall be stopped 30 minutes after the vacuum pump is stopped to fully cool the main motor; the dust on the motor shall be removed regularly to keep the heat sink of the motor clean to increase its heat dissipation capacity; the bus voltage of the vacuum pump shall be adjusted to 400V.